Acer AIR-204 - Manual (Page 27)

User Guide for AIR-104/AIR-204 4-9
After you have made your selection, click on the Next button. Depending on your
selection, proceed to consult either the Single-Modem Configuration section or the Dual-
Modem Configuration section below.
Single-modem configuration
From the Configuration heading on the ICC Menu, you should have clicked Internet
Connection Setup and then selected “I use one modem to access the Internet”. The
Internet Access Configuration screen appears in the Configuration Window of the ICC
browser screen.
Step 1 Enter the following information:
Phone Number for Internet Account: the telephone number used to access
your ISP account.
ISP Account Name: the username of your ISP account.
ISP Account Password: the password of your ISP account.
Step 2 On the line that reads Test Connection Using Port, click and drag to select
the port number (COM1 or COM2) of the modem that you will use to access
the Internet.
Step 3 Click on the APPLY and TEST button.
Note: When you click APPLY and TEST, the AIR-104/204 will immediately
attempt to place a call to your Internet Service Provider, using the modem you have
just identified. Watch the Message Window on the ICC browser screen for any
messages. If the connection is opened successfully, your LAN users should re-boot
their PCs, after which they may begin to access the Internet. If the connection is not
successful, the Message Window will provide you with information about the nature
of the problem.
Dual-modem configuration
If you have connected modems to both the COM1and COM2 ports of the AIR-104/204
(the built-in V.90 modem on the AIR-104/204 occupies the COM1 port) and you select
Chapter 4 Basic Configuration