Acer AIR-204 - Manual (Page 55)

User Guide for AIR-104/AIR-204 7-14
show lan statistics
Description: This command displays statistical information associated with the specified
profile or the LAN.
Examples:
AcerRouter> show isp1 statistics
interface: isp1
--------------------------------------------------------------------------------------------------------
Received Transmitted
--------------------------------------- ----------------------------------------------------------------
Total packets 0 0
Total octets 0 0
Multicast packets 0 0
Errors on interface 0 0
Packets dropped 0
Packets with unsupported protocol 0
Last update time (sec) 0
AcerRouter> show lan statistics
interface: lan
-------------------------------------------------------------------------------------------------
Received Transmitted
----------------------------------------------------------------------------------------------------------
Total packets 825 456
Total octets 75425 104293
Multicast packets 0 0
Errors on interface 0 0
CSMA collisions 0
Packets dropped 0
Packets with unsupported protocol 0
Last update time (sec) 1599
System Commands
change password
Description: This command allows the user to change the password used to log on to
the Command Line Interface or the Internet Configuration Console utility. A password is a
character string that starts with a letter and contains at least 6 and up to a total of 15
alphanumeric characters. The password is case sensitive. The default factory setting is
“password”.
If you forget the Internet Configuration Console password, the only way to recover is clear
the entire configuration and return the unit to its original state as shipped from the factory.
Unfortunately, this means that you have to re-enter all of your configuration data.
To clear the configuration and restore the password to the default, follow these steps:
Connect a console to the AIR-104/204 Aux/Console port. Turn off the AIR-104/204, then
turn it on again. In the console window, youll see the message Loading firmware...
When you see the message "Ready", immediately (within one second) press Control-C.
The AIR-104/204 will now reset. When this is complete, the AIR-104/204 will return all
settings to the factory default. The password will once again be “password”.
Chapter 7 Command Line Interface