Acer AIR-204 - Manual (Page 58)

7-17 User Guide for AIR-104/AIR-204
Set log level <1-10>
Description: This command changes the system log level, causing different events to be
logged into the system log table. It is often used for debugging purposes. The default log
level is 2, which means all events belonging to log level 2 or below will be logged into the
system log.
set prompt <prompt>
Description: This command defines a new command prompt. A prompt of up to 15
characters may be entered. The default prompt is Command>.
Example:
Command> set prompt "Yes, Master"
Yes, Master>
set time <hh:mm:ss>
Description: This command sets the time of the day (24-hour clock). Note that
the time will normally be set automatically when a browser first connects to the router
using the Internet Configuration Console utility.
Example:
Command> set time 20:33:00
set timezone <-12- +12>
Description: This command specifies the time zone for the AIR-104/204 location as an
offset from Greenwich Mean Time (GMT). The time zone is normally set automatically
when an HTTP browser first connects to the router using the Internet Configuration
Console utility.
Example:
Command> set timezone -8
Time Zone is set to GMT-8 hours.
show config
Description: A concise summary of the AIR-104/204 configuration is displayed.
Example:
AcerRouter> show config
IP Addr: 192.168.168.13 NetMask: 255.255.255.0 IP/IPX RIP: D/D
Port 1: MODEM PPP ENABLED Speed = Auto detect
Port 2: MODEM PPP ENABLED Speed = Auto detect
show connection log
Description: The connection log is displayed by the system. Up to 128 entries are
maintained by the router in wraparound fashion. For a complete description of these
entries, see Chapter 5, Advanced Configuration.
Example:
Command> show connection log
1 9/14/99 22:15:38 N/A(N/A): Triggered Detail: IP/TCP 192.168.168.229->63.192.
151.44 1905->139
2 9/14/99 22:16:28 Modem 1(isp1): Connected Detail: Outgoing Call to 14085553456
Chapter 7 Command Line Interface