AT&T E5934B - Manual (Page 13)

9
Getting started
9
Wall mounting
The base can be installed on any standard wall phone outlet as shown below. Choose a
location away from electronic equipment, such as personal computers, computer rout-
ers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Plug power adapter into an electrical
outlet not controlled by a wall switch.
Plug telephone line
cord into the telephone jack.
1) Connect telephone line cord and
power adapter to telephone jacks and
wall jacks, respectively, as shown on
page 7.
2) Install wall mount bracket onto set.
First put the two front wall mount
bracket tabs into the front notches
on bottom of telephone base, then
squeeze the rear tabs of the wall
mount bracket as you insert them into
the rear notches on the bottom of the
telephone base.
3) Position the wall mount brack-
et over the wall outlet mount-
ing pegs, and press and slide
the wall mount bracket down
firmly so it is held securely on
the outlet mounting pegs.