Nikon D200 - Manual (Page 102)

92
Ref
er
enc
e
—In
ter
v
al T
imer
Photogr
aph
y
To interrupt interval timer photography, highlight Start at the bottom of the interval
timer menu and press the multi selector up or down until Done is displayed, then press
the button.
Interval timer photography will also be interrupted if:
• A two button reset is performed (
97).
• Menu Reset is selected in the shooting menu ( 127).
• Bracketing settings are changed ( 73).
• The battery is exhausted.
Normal shooting will resume when interval timer photography ends.
Interrupting Interval Timer Photography
During Shooting
Shooting and menu settings can be adjusted freely while interval timer photography is in
progress. Note the following:
• Performing a two-button reset (
97) or changing bracketing settings ( 73) will cancel
interval timer photography.
• The monitor will turn off about four seconds before each interval.
Multiple Exposure
Interval timer shooting can be used to create a multiple exposure ( 86).
Shooting Mode
Regardless of the shooting mode selected, the camera will take the specifi ed number of
shots at each interval. In C
H
(continuous high speed) mode, photographs will be taken
at a rate of fi ve shots per second. In S (single frame), C
L
(continuous low-speed), and M
UP
(mirror up) modes, photographs will be taken at the rate chosen for Custom Setting d4
(Shooting Speed;
158). In (self-timer) mode, the shutter-release delay applies to
each photograph taken. In M
UP
mode, the mirror will be raised automatically immediately
before each shot.
Shooting Menu Banks
Changes to interval timer settings apply to all shooting menu banks ( 125). If shooting
menu settings are reset using the Menu Reset item in the shooting menu ( 127), interval
timer settings will be reset as follows:
• Start time: Now
• Interval: 00:01´:00˝
• Number of intervals: 1
• Number of shots: 1
• Start: Off