ROTHENBERGER ROWELD D 2/10 User Manual
Page 32
30
ENGLISH
7
Trouble-shooting
The following table lists potential operating upsets of the hand extruder, possible causes and
their remedies (fault diagnosis chart).
Should malfunctions occur which are not covered here or which cannot be traced back to the
cause stated, please contact ROTHENBERGER Werkzeuge GmbH.
Malfunction
Fault No.
Drive motor does not start
4, 5, 9, 10, 11, 12, 14, 15, 16, 17, 18, 19, 21
Drive motor switches off
5, 8, 9, 10, 11, 12, 14, 15, 16, 17, 18, 19, 21
No welding rod feed
1, 16, 17, 20
No extrudate conveyed out of welding shoe
1, 16
Extrudate output decreases during operation
1, 14, 16
No air supply
13
Integrated air supply system without function
22, 5
No hot air
2, 3, 4, 5, 18, 22
Hot air temperature below setpoint tempera-
ture
2, 3, 4, 8, 10, 14, 18, 22
Melt temperature below setpoint temperature
2, 3, 9, 11, 14
Extruder does not heat up
2, 3, 12, 22
Temperature above preset range
2, 3, 18, 19
Control fluctuates
3, 13, 19
Controller fault signal: OEAIR
2, 10, 19
Controller fault signal: OVERLD
22
Controller fault signal: OVHT
23
Controller fault signal: E
9
Controller fault signal: Fan-ERROR
19, 10
Controller signal: off
5, 6, 7, 8, 21