A.J. Antunes & Co SDC-500 9100532 - Manual (Page 4)

SteaMer DiSplay Cabinet SDC-500
4 P/N 1010968 Rev. D 03/12
A.J. Antunes & Co.
• warnInG eleCtrICal sHOCK Hazard.
faIlure tO fOllOw tHese InstruCtIOns
COuld result In serIOus Injury Or deatH.
- electrical ground is required on this appliance.
- do nOt modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
- do nOt use an extension cord with this unit.
- Check with a qualified electrician if you are
unsure if the appliance is properly grounded.
• this equipment is to be installed to comply with
the basic plumbing code of the building Officials
and Code administration, Inc. (bOCa) and the food
service sanitation manual of the food and drug
administration (fda).
• Do NOT clean this appliance with a water jet.
• Do NOT use abrasive cleansers or materials. They
may cause damage to the stainless steel finish.
• Chlorides or phosphates in cleaning agents (e.g.
bleach, degreasers, or detergents) could cause
permanent damage to stainless steel equipment.
the damage is usually in the form of discoloration,
dulling of metal surface finish, pits, voids, holes, or
cracks. this damage is permanent and nOt cov-
ered by warranty.
• The following tips are recommended for mainte-
nance of your stainless steel equipment.
- always use a soft, damp cloth for cleaning,
rinse with clear water and wipe dry. when
required, always rub in direction of metal pol-
ish lines.
- routine cleaning should be done daily using
soap, ammonia detergent, and water.
- stains and spots should be removed with a
vinegar solution.
- finger marks and smears should be removed
with soap and water.
- Hard water spots should be removed with a
vinegar solution.
in addition to the warnings and cautions in this manual, use
the following guidelines for safe operation of the unit.
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with a
properly grounded cord connector. Do NOt attempt to
defeat the grounded connector.
• Install or locate the equipment only for its intended use
as described in this manual. Do NOt use corrosive
chemicals in this equipment.
• Do NOT operate this equipment if it has a damaged
cord or plug, if it is not working properly, or if it has
been damaged or dropped.
• This equipment should be serviced by qualified per-
sonnel only. contact the nearest Roundup authorized
service agency for adjustment or repair.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
the following warnings and cautions appear throughout
this manual and should be carefully observed.
• Turn the power off, unplug the power cord, and
allow unit to cool down before performing any
service or maintenance.
• The procedures in this chapter may include the use
of chemical products. these chemical products
will be highlighted with bold face letters followed
by the abbreviated HCs (Hazard Communication
standard). see Hazard Communication standard
manual for the appropriated material safety data
sheets (msds).
• The unit should be grounded according to local
electrical codes to prevent the possibility of electri-
cal shock. It requires a grounded receptacle with
separate electrical lines, protected by fuses or
circuit breaker of the proper rating.
• All electrical connections must be in accordance
with local electrical codes and any other applicable
codes.
ImpOrtant safety InfOrmatIOn (continued)