A.J. Antunes & Co SDC-500 9100532 - Manual (Page 6)

SteaMer DiSplay Cabinet SDC-500
6 P/N 1010968 Rev. D 03/12
A.J. Antunes & Co.
figure 1. sdC-500 steamer display Cabinet
unpacking
1. Open the large box. it should contain the
following items:
• SDC-500 Unit (Figure 1)
• 5 Shelves (Figure 2)
• 1 Diffuser (Figure 2)
2. Remove the unit from the box. Remove all packing
materials and protective coverings from the unit and
parts.
3. Open the front Door and remove the Diffuser.
nOte: If any parts are missing or damaged, contact a.j.
antunes & Co. ImmedIately at 1-800-253-2991 (toll free
in the u.s. and Canada) or at 630-784-1000.
4. Wash the Diffuser and the 5 shelves in soap and
water, then rinse and allow to air dry.
5. Wipe all metal of the unit with a hot, damp cloth.
6. Wash the inside and outside of all glass surfaces with a
hot, damp cloth.
nOte: do nOt use a dripping wet cloth. wring out
before use.
4. install Diffuser and shelves into unit.
equipment setup
When placing the unit into service, pay attention to the
following guidelines.
• Make sure power off and the unit is at room
temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work
surface.
• The unit must have a minimum of 1 inch
clearance from walls and other items.
Make sure the line voltage corresponds to the stated voltage
on the unit specification label.
InstallatIOn
diffuser
shelves (5)
figure 2. sdC-500 accessories
LINE FULL
PUSH TO RESET
LINE REFILL
figure 3. sdC-500 Control panel
thermostat
Control
Hi-limit
reset switch
power
switch
water tube