A.J. Antunes & Co SDC-500 9100532 - Manual (Page 7)

SteaMer DiSplay Cabinet SDC-500
7 P/N 1010968 Rev. D 03/12
A.J. Antunes & Co.
Installing shelves
the support Racks and shelves are designed with a “notch
and tab” system. the tabs on the shelf drop into the notches
in the support Racks. When properly seated, the shelf will
slide in and out of the unit without detaching.
1. Open the front door and insert the shelf onto the
desired support Racks (figure 4).
nOte: Insert the shelves tab end first.
2. slide the shelf into the unit until the tabs drop into the
slots at the back of the support Racks.
3. Move the shelf in and out of the unit. if the shelf can
be pulled completely out of the unit, it is not correctly
installed. Repeat these steps until each shelf cannot be
pulled directly out of the unit.
support
rack
rear
Corner
post
front
Corner
post
InstallatIOn (continued)
figure 5. adjusting shelf Height
adjusting shelf Height
inspect the support Racks. they have been pre-installed in
the unit. ensure that they are the proper distance apart for
the food product. follow these steps if the shelf height needs
adjustment:
1. turn the power off and allow it to cool to room
temperature.
2. Open the front Door and, if necessary, remove any
food product.
3. Remove the shelves as needed (refer below to the sec-
tion titled removing Shelves).
4. Lift up on the front portion of the desired support Rack
until it is free from the front corner Post. then, slide the
support Rack out of the rear corner Post (figure 5).
repeat this on the opposite support bracket.
5. install the support Rack at the new location by inserting
the back end of the rack into the rear corner Post and
then sliding the front of the rack down onto the tab of
the front corner Post (figure 5).
LIN E
PO WER
LIN E
Slide the Shelf along
the support until the
Shelf Tab drops down into
the Slot in the Support.
Slot in
Support
Shelf Tab
figure 4. Installing shelf
removing shelves
to remove shelves from the unit:
1. Open the front door and remove any product.
2. While lifting upwards on the shelf, slide it so that the
tabs release from the support Rack.
3. Pull the shelf out and away from the unit.
tab
slot