AccuTemp EVOLUTION ELECTRIC STEAMER - Manual (Page 6)

MP4008-0910 EVOLUTION STEAMER OWNERS MANUAL
Page 4
SINGLE STEAMER STAND INSTALLATION
The AccuTemp SNH10 single stand is equipped with adjustable height feet and the model
SNH11 single stand is equipped with non-adjustable height casters. Both can be used with a
single E6 model Evolution steamer. Before mounting a steamer on the SNH11 stand, engage
the two front locking casters, pressing on the “ON” handle of the brake mechanism. To
mount the steamer, carefully lift and place it on the horizontal mounting brackets
ensuring that the (4) mounting holes on the underside of the Evolution are lined up with
mounting holes of the brackets. Then, using a 7 /
16
” wrench, fasten one pair of the 1 /
4
” -20
hex bolt and 1 /
4
” split lock washer through the underside of each stand bracket mounting
hole into the Evolution and tighten securely. With the SNH10 stand, level the steamer by
adjusting the feet found at the ends of each stand leg, either up or down as needed.
WARNING
When using a stand that is equipped with casters, the floor surface must be level
and flat. Failure to do so can result in a “tipping” hazard that could result in
serious injury .
!
DOUBLE STEAMER STAND INSTALLATION
The AccuTemp SNH20 double stand is equipped with adjustable height feet and the
AccuTemp SNH21 double stand is equipped with non-adjustable height casters. Both
stands can accommodate two E6 model Evolutions. Before mounting a steamer on the
SNH21 stand, engage the brakes on the two front locking casters, pressing on the “ON”
handle of the brake mechanism. Always mount the first EVOLUTION on the bottom of the
stand. To mount the bottom steamer, carefully lift and place it on the horizontal mounting
brackets, ensuring that the (4) mounting holes on the underside of the Evolution are lined
up with the mounting holes on the brackets. Then, using a 7/16” wrench, fasten one pair
of the 1/4"-20 hex bolts and 1/4" split lock washers through the underside of each stand
bracket mounting hole into the Evolution and tighten securely. Once the bottom steamer
has been installed, carefully lift and place the top Evolution steamer on the horizontal
mounting brackets, ensuring that the (4) mounting holes on the underside of the Evolution
are lined up with the mounting holes on the brackets. Then, using a 7/16” wrench, fasten
one pair of the 1/4"-20 hex bolts and 1/4" split lock washers through the underside of
each stand bracket mounting hole and tighten securely. With the SNH20 stand, level the
steamers by adjusting the feet found at the ends of each stand leg, either up or down as
needed.
INSTALLATION