AccuTemp EVOLUTION ELECTRIC STEAMER - Manual (Page 8)

MP4008-0910 EVOLUTION STEAMER OWNERS MANUAL
Page 6
 Check local codes to determine exactly what type of anti-backflow/anti-siphon device
is necessary to meet local requirements.
 Design the water supply line so the unit can be moved for service. Install a manual
water shutoff valve between the water supply line and the steamer supply line.
 The Garden Hose Thread (GHT) connector used must be NSF rated for food grade
service.
 Do not apply pipe thread sealant to GHT connections.
 Install a manual water shut-off valve (Main Water Shutoff Valve) (not provided)
between the cold water supply line and the appliance.

must be less than 180 °F.
 A NSF rated reinforced rubber or braided stainless steel appliance hose rated for the
temperature and pressure of the water supply with a 3/4” garden hose type
connection is required.
 The hose must not be sharply bent, kinked or twisted.
 If the steamer is close to a wall, use a right angle fitting to prevent kinking the hose
 Flush the water supply line before connecting the line to the appliance.
 Connect the water supply line to the steamer.
DRAIN LINE CONNECTION –CONNECTED MODELS ONLY
Floor Drain
The steamer should be located close to but not over a floor drain. Connect a ¾” reinforced
rubber hose rated for 212° F or higher to the drain fitting underneath the steamer with a hose
clamp. Run the hose to the drain. DO NOT directly plumb the steamer to the drain, Leave a
one-inch air gap between the hose and the drain as shown in Fig 4.
WATERLINE CONNECTION - CONNECTED MODELS
Fig. 4
INSTALLATION