Detergent/suction operation, Applying the detergent solution, Vacuuming operations – Karcher SGV 8-5 User Manual

Page 26: Combined operation, After operation with detergent / rinsing, Empty wastewater container, Putting down the accessories, Turn off the appliance, Self-cleaning

Advertising
background image

– 7

Only SGV 8/5:
Note: Test the detergent resistance of the
surface to be cleaned.
Note: With this operating mode the hand-
wheel has the "Apply cleaning solution"
function in every position. The steam/hot
water/cold water operation is deactivated.

Set the rotary switch to detergent/suc-
tion operation.

Press the steam switch. Cleaning solu-
tion is dispensed as long as the button
is pressed.

Start suction operation: Press suction
button briefly.

End suction operation: Press suction
button again briefly.

Press the steam switch and at the same
time press the suction button briefly.
Suction operation starts and the clean-
ing solution is dispensed at the same
time.

Note: As soon as the entire content of the
detergent container has been applied and
vacuumed off again, the wastewater con-
tainer must be emptied in order to prevent
excessive formation of foam.

Only SGV 8/5:

After operation with detergent, the ap-
pliance must be rinsed.

If the rotary switch is not set to rinsing
after operation with a detergent, the fol-
lowing message appears on the dis-
play:

Set rotary switch to rinsing.

Hold down the steam switch. Rinsing
starts. Hold the floor nozzle over a drain
or start suction operation.

Rinsing in process. Time elapsed is dis-
played.
Note: If the steam switch is released, the
rinsing process stops. When pushing the
steam switch again, the rinsing process is
continued.

Note: The rinsing process can be extended
by pushing the steam switch longer.

Open the cover of the wastewater con-
tainer.

Push the locking mechanism of the
wastewater container up.

Remove the wastewater container.

Unlock the closure of the wastewater
container and remove the lid.

Empty the wastewater reservoir.

During short interruptions of work, the floor
nozzle can be brought into the parking po-
sition and the steam suction pipe can be
snapped in place.

Set the rotary switch on the appliance to
"0/OFF".

Pull out the mains plug.

Only SGV 8/5:

Set the rotary switch on the appliance to
self-cleaning.

-Alternating display-

Detergent/suction operation

Applying the detergent solution

detergent

Vacuuming operations

Combined operation

After operation with detergent /

rinsing

select flushing

program

start

flushing

flushing

# # # # _ _ _ _ _ _

flushing
finished

Empty wastewater container

Putting Down the Accessories

Turn off the appliance

Self-cleaning

prepare

self-cleaning

26

EN

Advertising
This manual is related to the following products: