Karcher KM 150-500 LPG - Manual (Page 29)

- 12
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.

Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Note: Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.
 Open the fuse holder.
 Check the fuses.
Note: The fuses FU 01 and FU 14 are lo-
cated in the motor compartment.
 Replace defective fuses.
Note: Only use fuses with identical safety
ratings.
We hereby declare that the machine de-
scribed below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.
The undersigned act on behalf and under
the power of attorney of the company man-
agement.
Authorised Documentation Representative
S. Reiser
Alfred Kärcher GmbH Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Phone: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2011/03/01
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Changing the headlight bulb (option)
Changing the blinker bulb (option)
Replacing fuses
FU 01 Main fuse 60 A
FU 02 Gas cylinder fill level
indicator 5 A
FU 03 Safety relay
Multifunction display 10 A
FU 04 Blinker switch 10 A
FU 05 Time relay
Seat contact switch 30 A
FU 06 Ventilator motor hy-
draulic cooler 25 A
FU 07 Program selection
switch
Waste container func-
tions 10 A
FU 08 Horn 10 A
FU 09 Left lighting 7,5 A
FU 10 Right lighting 7,5 A
FU 11 Front work lights (low
beam) 10 A
FU 12 Vibrator system
Beacon lamp 20 A
FU 13 Water pump
Capacitor ventilator
Cabin lighting
Wiper
3. Side brushes
Blower motor cabin 10 A
FU 14 Fanmotor capacitor 40 A
EC Declaration of Conformity
Product: Ride-on vacuum sweeper
Type: 1.186-xxx
Relevant EU Directives
2006/42/EC (+2009/127/EC)
2004/108/EC
2000/14/EC
Applied harmonized standards
EN 60335–1
EN 60335–2–72
EN 55014–2: 1997+A1: 2001+A2: 2008
Applied national standards
CISPR 12
Applied conformity evaluation method
2000/14/EC: Appendix V
Sound power level dB(A)
Measured:
Guaranteed: 107
Warranty
CEO Head of Approbation
29 EN