Aiwa MM-RX400 - Manual (Page 15)

ENGLISH
15
ENGLISH
Connecting the MM-RX400 player to your computer
Use the supplied USB cable to connect
the MM-RX400 player to your computer,
as shown below.
1 Connect the series A connector
(the larger one) to the computer’s
USB port.
2 Connect the series B connector
(the smaller one) to the USB port
connector of the MM-RX400
player.
3 Turn on the player by holding the
e / s button pressed until
“CONNECT USB” appears on the
display of the MM-RX400 player.
If you connect the USB cable to the
MM-RX400 player while it is in
Playback mode, the player will stop
playback and display “CONNECT
USB.”
1
2
3
PC USB port
USB port
connector
Series B
connector
Supplied USB cable
Series A connector
Note
If the “Add New Hardware Wizard”
appears after you turn on the MM-RX400
player in step 3, install the USB driver,
following the procedure described in
“Installing the USB driver” (page 16).
• Before connecting the MM-RX400 player
to your computer with the supplied USB
cable, be sure to fully charge the battery.
If “LOW BATT” appears on the display
of the MM-RX400 player when it is
connected to the computer, disconnect
the MM-RX400 player from the
computer, then reconnect it after fully
charging the battery.
• The following actions are strictly
prohibited while transferring music files
or formatting the memory media. Doing
so may cause not only the computer to
freeze up but also the memory media to
be damaged.
— Disconnecting the USB cable from
the MM-RX400 player or the
computer
— Removing the battery from the
MM-RX400 player
— Removing the MultiMediaCard from
the MM-RX400 player
• Do NOT turn on or off the computer
while the MM-RX400 player is connected
to the computer. This may cause
damage to the MM-RX400 player or the
music files stored on it.