AT&T TL7610 - Manual (Page 12)

6
Getting started
Headset base installation
Installation options
IMPORTANT: If you purchased model TL7611, or if you purchased
a model TL7000 handset lifter (purchased separately), follow the
installation instructions in the TL7000 handset lifter manual and
then skip to page 12 of this manual.
If you purchased model TL7610 (without handset lifter), you have
three installation options:
Option 1: Use the headset with a single standard telephone line with
a corded or cordless telephone.
Option 2: Use the headset with a single standard telephone line as a
stand-alone product.
Option 3: Use the headset with a multiple line corded telephone
(such as the AT&T 1080, 1070, 1040) or a digital business
system (such as a proprietary PBX telephone system).
Cord labels
The cords provided with your headset have colored labels
attached to help you plug them into the headset base. The back
of the headset base has colored dots above the jacks, and the
jack names on the rear bottom plastic piece of the headset base
that correspond to the colored labels on the cords.
If you are using installation option 3, you may attach the provided
light blue colored label to the end of your telephone curly
handset cord that you plug into the headset base.
Digital subscriber line (DSL)
If you subscribe to high-speed Internet service (digital subscriber
line - DSL) through your telephone lines, you must install a DSL
filter between the telephone base and the telephone wall jack.
The filter prevents noise and caller ID problems caused by DSL
interference. Please contact your DSL service provider for more
information about DSL filters.