Adsl s, Led i, Etting – ADC Megabit Modem 700F User Manual
Page 30: Ervice, Hecking, Ndications
Setting Up ADSL Service
20
Megabit Modem 400F, 500L, 600F, and 700F User Manual
S
ETTING
U
P
ADSL S
ERVICE
The service provider sets up the ADSL parameters for your service. The modem must have
the ADSL SYNC LED lit before you can connect sessions with your service provider. Verify
SYNC in the following section,
“Checking LED Indications.”
C
HECKING
LED I
NDICATIONS
The table below describes LED indications for all operational modes. LEDs on the modem front
panel provide continual status at-a-glance for network and modem connections.
LED
State
Description
PWR
On green
Modem has power.
Off
Modem does not have power.
LAN
LINK
On green
A PC, hub, or other network device is connected to the modem
10/100BASE-T interface.
Off
No device is connected to the modem 10/100BASE-T interface.
TX
Flashing green
Modem is transmitting data to devices on the LAN.
Off
Modem is not transmitting data to the LAN.
RX
Flashing green
Modem is receiving data from devices on the LAN.
Off
Modem is not receiving data from the LAN.
ADSL
SYNC
On green
ADSL transceiver is synchronized and in normal operation mode.
Flashing green
ADSL transceiver is in a start-up sequence.
Off
ADSL modem transceiver is not detecting a transceiver at the far end.
TX
Flashing green
Modem is transmitting data to the service provider.
Off
Modem is not transmitting data to the service provider.
RX
Flashing green
Modem is receiving data from the service provider.
Off
Modem is not receiving data from the service provider.
MAR
On green
ADSL margin is at or above the value set by the service provider.
Off
ADSL margin is below the value set by the service provider.
OH
On yellow
Telephone receiver is off hook.
Off
Telephone receiver is on hook.