Aico Ei261DENRC User Manual
Page 18
11. Connect the mains power to the alarm circuit. Check the green light is on.
The CO Alarm is now fully operational and will provide protection against a build up of Carbon
Monoxide gas 70 seconds after it is connected to the mains supply.
12. The unit may be tamperproofed further by removing the knockout in the sidewall of the mounting plate
(as shown in
Figure 4
) and inserting the self tapping screw (3mm diameter, 12mm long) after the unit
is on the mounting plate.
L N IC
EARTH
(IF PRESENT)
L - LIVE
N - NEUTRAL
IC - INTERCONNECT
TERMINAL SCREWS
RECESSED WIRING AREA
MAINS WIRING
18
L N IC
KNOCK OUT FOR
SURFACE WIRING
CONDUIT
WIRING
CONDUIT
INSERT SCREWDRIVER TO LIFT
AND REMOVE WIRE COVER
KNOCK OUT
FOR SURFACE WIRING
CONDUIT
SEALING GASKET
(MUST BE IN PLACE)
WIRING
CONDUIT
Figure 5 - Surface Wiring
Figure 6 - Recessed Wiring
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 18