Sony DCR-PC5 - Manual (Page 63)

63
Editing
Dubbing only desired scenes – Digital program editing
(2) Setting the modes to cancel the recording pause on the
VCR
1 Select PAUSEMODE, then press EXEC.
2 Select the mode to cancel recording pause on the VCR, then press EXEC.
The correct button depends on your VCR.
Refer to the operating instructions of your VCR.
The buttons to cancel recording pause on the VCR
The buttons vary depending on your VCR. To cancel recording pause of your VCR:
• Select “PAUSE” if the button to cancel recording pause is X.
• Select “REC” if the button to cancel recording pause is z.
• Select “PB” if the button to cancel recording pause is N.
(3) Setting your camcorder and the VCR to face each other
Locate the infrared ray emitter of your camcorder and face it towards the remote sensor
of the VCR.
Set the devices about 11 7/8 in. (30 cm) apart, and remove any obstacles between the
devices.
VCR
Remote sensor
1 2
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET. EXEC
PAUSE
REC
PB
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET. EXEC
PAUSE