Sony HDR-XR160 - Manual (Page 125)

15
Table of C
on
ten
ts
Enjo
y U
seful F
unc
tions
Inde
x
US
 A/V Remote Connector (33)
 Grip belt (24)
 Built-in USB Cable (15)
 Memory card access lamp (23)
While the lamp is lit or flashing, the
camcorder is reading or writing data.
 Tripod receptacle
Attach a tripod (sold separately) to the
tripod receptacle using a tripod screw (sold
separately: the length of the screw must be less
than 5.5 mm (7/32 in.)).
 Memory card slot (23)
 BATT (battery) release lever (16)
Wireless Remote Commander
(HDR-CX360/CX360V/PJ10/PJ30/
PJ30V/PJ50/PJ50V)
 DATA CODE button (91)
Displays the date and time, camera setting
data, or coordinates (HDR-CX360V/PJ30V/
PJ50V) of the recorded images when you press
this button during playback.
 PHOTO button (27)
The on-screen image when you press this
button will be recorded as a still image.
 SCAN/SLOW buttons (31)

 /  (Previous/Next) buttons (31)
 PLAY button
 STOP button
 DISPLAY button (25)
 Transmitter
 START/STOP button (25)
 Power zoom buttons
 PAUSE button
 VISUAL INDEX button (29)
Displays an Index screen during playback.

 /  /  /  /ENTER buttons
When you press any of these buttons, the
orange frame appears on the LCD screen.
Select a desired button or an item with
 /  /  /  , then press ENTER to enter.
Notes
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 123).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the orange frame disappears. When
you press any of  /  /  /  , or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen using  /  /  /  .





Insulation sheet