Sony PEG-UX40 - Manual (Page 80)

Customizing your CLIÉ™ handheld (Preferences) 80
Setting the Network preferences for a wireless LAN (for PEG-UX50 only)
2 Power Save:
The Power Save function is enabled by default. If the communication
reception of the wireless LAN is low, cancel the Power Save function,
and communicate with the maximum power. In this case, the battery of
your CLIÉ handheld is quickly exhausted. Enable Power Save function
in normal use. To cancel the Power Save function, tap
next to
[Power Save:] to change to .
3 IP address:
DHCP (Dynamic Host Configuration Protocol) is enabled by default.
When DHCP is cancelled, the
IP Address screen is displayed and you
can manually set up an IP Address, Netmask(Subnet mask),
Router(Gateway), Primary DNS, and Secondary DNS. To cancel
DHCP, tap
next to [IP address:] to change to .
4 Auto Connect:
If this item is enabled, when your CLIÉ handheld is connected to a wireless
LAN access point automatically (refer to P.82), this setup is treated as one
for selection. Auto Connect is enabled by default. To cancel Auto Connect,
tap
next to [Auto Connect:] to change to .
10
Tap [OK].
The SSID Setup screen is closed, and the Wireless LAN Setup screen
which added the new SSID setting under [SSID:] is displayed.
11
Tap [OK].
The Wireless LAN Setup screen is closed, and the Preferences
screen is displayed.