Sony HMZ-T3W - Manual (Page 17)

17
Using the Stand
1
Fix the supplied stand to the
battery unit.
Insert the projection of the stand into
the hole on the bottom of the battery
unit.
2
Place the battery unit facing the
SONY logo side toward the
processor unit.
After using
Remove the stand from the battery
unit and hook it on the cable of the
battery unit.
Checking the Strength of Radio
Waves
Press the MENU button on the head
mounted unit to display the menu,
then select “Information.” The
strength of radio waves appears on
the top right of the Information screen
(page 28).
Strength of radio waves
To maintain stable connection, use
the system where radio waves are as
strong as possible. The recommended
level of radio wave strength is 2 or
higher as a guide.
Notes on Wireless Communication
• The system cannot achieve wireless
communication if there is an obstruction
between the processor unit and the
battery unit (e.g. room-to-room
communication).
• In the following cases, the status of
wireless communication between the
processor unit and battery unit is
adversely affected, decreasing the
possible communication distance and
generating disturbances in video and/or
audio (picture degradation, signal
interruption, noise, etc.).
– When the system is used in a room of
reinforced concrete or stone walls or
floor, or with floor heating activated
– When there is some obstruction, such
as a partition, door, fireproof glass,
furniture with metal materials, or an
electric appliance, between the
processor unit and the battery unit
SONY logo
Processor unit
Level of radio wave strength
Strong Weak
4 3 2 1 0