Sony HMZ-T3W - Manual (Page 43)

43
 Wireless
Symptom Cause/Action
No wireless connection
Audio or video interrupted
or stops
The WIRELESS indicator
does not light
 Make sure that the processor unit and the battery unit
are turned on.
 It may take a while before the image appears on the
screen.
 The radio waves become weakened or interrupted,
depending on the distance or orientation of the
processor unit and the battery unit, or an obstruction
between the two units.
Make the positions of the processor unit and the battery
unit nearer (approximately 3 m or less), and orient the
two units with their SONY logos facing each other.
Wireless communication quality degrades if the panel
with the SONY logo (the side with antenna installed) of
the battery unit faces the floor, or away from the
processor unit.
 If wireless communication cannot be achieved
successfully with the battery unit positioned flat, attach
the supplied stand to the battery unit and adjust its
orientation so that the SONY logo faces the processor
unit (page 16).
 Use the system where there are no obstructions
between the processor unit and the battery unit.
 There may be interference from other wireless devices.
Turn off those devices and check if the phenomenon
improves.
 The transmission of audio and video signals, or the
correct operation of the unit may be affected by
interference if more than three wireless devices using
the same frequency band (60 GHz), including this
system, are used.