Sony HMZ-T3W - Manual (Page 47)

47
For environment protection, remove
the built-in lithium-ion battery from
the system.
Before removing the battery, drain the
battery by removing the AC adaptor
and using the system only with the
battery.
Removing the Battery Case
1
Remove the four screws, then
remove the bottom panel from the
battery unit.
2
Remove the three screws and the
front panel, then disconnect the
connector.
• Be careful not to damage the cord
cover with metallic tweezers, etc.
when you disconnect the connector.
3
Remove the six screws and the
battery case.
Drop off the remove battery case with
the battery attached for recycling.
• Do not remove the battery from the
battery case.
When Disposing of the
System
• Take out the lithium-ion battery
for recycling.
Do not open the cabinet other
than when disposing of the
system.
• Be careful not to touch the end of
a screwdriver to the lithium-ion
battery when removing the
battery case. If the battery is
damaged, there is risk of leakage,
heat generation, fire, or explosion.
Screw
Bottom panel
Rubber foot
Note
Note
Connector
Front panel
Battery Battery case