Sony FWD-S42H1 - Manual (Page 64)

18 GB
Optional Adaptors
The terminal of the OPTION slot qj (page 12) on the
side of the equipment is a slot-in type. It can be
switched to the following optional adapter (not
supplied).
For details on installation, consult your Sony dealers.
For details on the optional adaptors for system
expansion, see each instruction manual with this
manual.
COMPONENT/RGB INPUT Adaptor BKM-
FW11
1 Y/G, P
B
/C
B
/B, P
R
/C
R
/R IN (BNC): Connects to
the analog RGB signal or component signal output
of a piece of video equipment or PC.
2 HD, VD IN (BNC): Connects to the
synchronization signal output of a PC.
When inputting a component signal, be sure not to input sync
signals to the HD and VD connectors. If you do so, the
picture may not be displayed properly.
3 AUDIO (Stereo mini jack): Inputs an audio
signal. Connects to the audio output of a piece of
video equipment or PC.
HDMI INPUT Adaptor BKM-FW15
You can enjoy enhanced or high-definition video, and
two-channel digital audio.
The appropriate mode for a piece of audio/video
equipment or PC is automatically selected in
accordance with the connected equipment.
Be sure to use only an HDMI cable (not supplied) that bears
the HDMI logo.
HD-SDI/SDI INPUT Adaptor BKM-FW16
Connects to the HD-SDI signal output of a piece of
video equipment.
MONITOR CONTROL Adaptor BKM-FW21
1 CONTROL S IN/OUT (Mini jack): You can
control pieces of multiple equipment with a single
remote control when the display is connected to
the CONTROL S connector of the video
equipment or another display. Connect the
CONTROL S OUT connector on this adaptor to
the CONTROL S IN connector of the other
equipment, and connect the CONTROL S IN
connector on this adaptor to the CONTROL S
OUT connector of the other equipment.
2 REMOTE (D-sub 9-pin): This connector allows
remote control of the display using the RS-232C
protocol. For details, contact your authorized
Sony dealers.
• The REMOTE connector and the REMOTE (LAN)
connector qs (page 11) on the side of the equipment
cannot be used at the same time.
• When using the REMOTE connector, select “Option” in
“Network Port”. (page 32)
STREAMING RECEIVER Adaptor BKM-FW50
This adaptor enables you to use this display for digital
signage.
You can easily play back movies, still images or
background music in designated data formats by just
inserting a recording media. You can also use a
network to view images from a remote computer on
the display.
A compact flash memory card is required.
Note
Note
Note
Notes