Screen settings, Pap setting – Sony FWD-S42H1 User Manual
Page 72
26
GB
Screen Settings
For Video Input
To highlight an option and to change settings, press
F
/
f
/
G
/
g
.
Press
to confirm the selection.
The “Screen” settings include the following options:
PAP Setting
Allows you to show two pictures from different signal sources, such as a PC and a
video, side by side.
“PAP”
“Off”: Disables “PAP” function.
“P&P”: Shows two pictures side by side at the same time.
“PinP”: Displays two pictures as the inset picture within the main picture.
For P&P
“Active Picture”: Selects the screen to operate.
“Left”: You can activate the left picture to operate it.
“Right”: You can activate the right picture to operate it.
“Swap”: Swaps the two pictures side by side.
“Picture Size”: Adjusts the balance between two pictures side by side. Adjust the
balance by pressing
G or g button, and then press
button to set the adjustment.
For PinP
“Active Picture”: Selects the screen to operate.
“Main”: You can activate the main picture to operate it.
“Sub”: You can activate the inset picture to operate it.
“Swap”: Swaps the main and the inset pictures.
“Picture Size”: Adjusts the size of the inset picture. Select from “Large” or “Small”.
“Picture Position”: Adjusts the position of the inset picture with
F/f/G/g, then
press .
Tip
You cannot change the aspect ratio in the “PAP” mode. The picture is displayed in the last
aspect ratio used prior to selecting “PAP” mode.
VIDEO
Available combination of two pictures
1) Supported when “Display” is set to “YUV” or when “Option” is set to “RGB” in “RGB/YUV”.
2) Supported when “Display” is set to “RGB” or when “Option” is set to “YUV” in “RGB/YUV”.
Tip
Output from BKM-FW50 is considered as RGB output shown in the table in the “PAP” mode.
S Video
Video
RGB/YUV
DVI
OPTION
RGB
Component
RGB
Component
HDMI
HD-SDI/
SDI
S Video
a
a
a
a
a
a
a
Video
a
a
a
a
a
a
a
RGB/YUV
RGB
a
a
a
a
2)
a
a
Component
a
a
a
a
1)
a
a
DVI
a
a
a
a
a
a