Sony FWD-S42H1 - Manual (Page 76)

30 GB
Setup Settings
To highlight an option and to change settings, press
F
/
f
/
G
/
g
.
Press to confirm the selection.
The “Setup” settings include the following options:
Language Select to display all on-screen settings in your language of choice: “English”,
“Français”, “Deutsch”, “Español”, “Italiano” or “
”.
Timer Setting You can adjust time, display the built-in clock, or set the timer to make the display
power on/off at a predetermined time.
“Clock Set”: Sets the day of the week and the hour of the day.
“Date Set”: Sets the date (year, month, date). The day is automatically set.
“Time Set”: Sets the time.
“Clock Display”: Displays the currently set time on the screen when set to “On,” by
pressing the display button on the remote control.
“On/Off Timer”: Sets the day of the week and the hour of the day.
If the built-in clock tends to lose time, the internal battery may be exhausted. Please
contact your authorized Sony dealer to have the battery replaced.
ECO Mode “Off”: Select to view picture without the benefit of power saving.
“Low”/“High”: Select to change brightness and reduce power consumption.
Status Display “On” makes input signal and “Aspect” information appear on the screen for about 5
seconds when the display is turned on, and the input signal information appear for
about 5 seconds when the input signal is switched, while “Off” disables display of
status information.
Tip
You can display the input signal and “Aspect” information by using DISPLAY on the remote
control regardless of the “Status Display” setting.
Speaker Out “On”: Enables sound to be emitted from the speakers.
“Off”: Disables sound to be emitted from the speakers.
Advanced Setup “Control Setting”: This menu is used for settings of operation of the display and the
remote control.
“Index Number”: You can change the index number of the display if necessary.
Select to set the index number of the display with
F/f and press (ENTER) to
confirm the setting.
When you set the “Index Number”, use the buttons on the display. The “Index Number”
cannot be set with the remote control.
“Control Mode”
“Display+Remote”: You can operate the display with the control buttons on
the display and the remote control.
“Display Only”: Disables the remote control function. You can make
settings for the display only using the control buttons on the display.
“Remote Only”: Disables the controls on the display. You can make
settings for the display only using the remote control.
DVI
Note
Note