Sony RM-NX7000 - Manual (Page 22)

 The label cannot be left blank. Be sure to enter at least one letter.
 You cannot set the same label as an existing Component key.
Hint
You can copy and paste text in the text box of "Label" by using the shortcut menu (right-click menu) or by using the shortcut keys.
o Font s ize
o Select the font size from the drop-dow n list by clicking .
o You can select "Small," "Medium," or "Large." The default setting is "Large."
o Te xt color
The text color is displayed in the text color box. You can select another color for the label by clicking "Change color" to display the "Color select"
dialog box.
o Te xt align
o Select the alignment of text in the Component key from the drop-dow n list by clicking . You can select either "Center" or "Top - Left." The default
setting is "Center."
o Pre s s gap
o Select the Component key gap (the direction/distance the label moves to w hen the Component key is pressed) from the drop-dow n list by clicking
. The gap value ranges from -5 to 5. If the value is below zero, the label moves to the upper left w hen the Component key is pressed. If the value
is above zero, the label moves to the low er right w hen the Component key is pressed. The default setting is 2.
o Dis play labe l on the s k in
o Select w hether to display the characters (that you entered in the "Label" box) on the Component key. If you uncheck this box, the characters are
hidden. This box is checked by default.
Hint
If you change the label settings, the changed label is displayed in the "Preview " area in the low er left of the dialog box.
13. Click "OK."
The "Add component" w izard closes, and the new Component key is created for the page selected in step 2.
Hint
You can check in the EMULATE mode if the new Component key has been created properly. To sw itch to the EMULATE mode, click the EMULATE sw itch in the
center of the w indow .
Page 22