Asus Pentium III IDE RAID Server AP110 - Manual (Page 29)

AP110 Server User’s Manual 29
Connect the Cables
1. Connect one end of the IDE
cable to the IDE connector at
the back of the drive, matching
the red stripe on the cable with
Pin 1 on the IDE connector.
2. Connect a power cable (plug
marked P3 or P4) to the power
connector at the back of the
drive.
3. Connect the other end of the
IDE cable to the primary IDE
connector (blue connector) on
the motherboard.
IDE Cable
Red Stripe to Pin 1
Power Cable
(P3 or P4)
2.6 Install a Hard Disk Drive
IDE HDD Cabling
The picture on the left shows an
installed HDD.
Primary IDE Connector