Sony MZ-B10 - Manual (Page 51)

51
While Editing
There is no R-
channel sound
output when
playing a track
recorded from a
cassette deck or
through an
amplifier, or when
listening to sound
from a cassette
deck or amplifier. • There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
The optional foot
control unit does
not work properly. • The recorder is not set for foot control unit use.
, Set “FOOT SW” in the menu to “SW ON” (page 40).
Symptom Cause/Remedy
The lid does not
open. • The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
Editing cannot be
done. • The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
Track marks
cannot be erased. • This is due to the MiniDisc system limitations. When the data of a
track is fragmented, the track mark of a fragment under 12 seconds
long (recorded in stereo), 24 seconds long (recorded in LP2 stereo
mode or monaural mode), or 48 seconds long (recorded in LP4
stereo mode) cannot be erased. You cannot combine a track
recorded in stereo and a track recorded in monaural; nor can you
combine a track recorded with digital connection and a track
recorded with analog connection.
The disc cannot
edit on other
component. • The component does not support MDLP.
, Edit on other component that support MDLP.
Symptom Cause/Remedy