Sony MZ-B10 - Manual (Page 52)

52
While using group function
Others
Symptom Cause/Remedy
The group
function does not
operate. • While using a disc without group setting, an attempt was made to
select some group-related menu.
, Use a disc with group setting.
A track cannot be
recorded to a new
group. A new
group cannot be
created. • This is due to the MiniDisc system limitations. If the total number
of characters for the disc can store exceeds approximately 1,700, a
new group cannot be created even though group mode is on. It is
also impossible to make group settings at this time.
Symptom Cause/Remedy
The display
window is not
normal. • The recorder was disconnected from the power source.
, Let the recorder sit for a while, or disconnect the power source,
reconnect it, and then press any of the operation buttons.
The recorder does
not work or works
poorly. • The volume is low.
, Turn up the volume.
• No disc is inserted.
, Insert a recorded disc.
• The HOLD function is turned on (“HOLD” appears in the display
when you press an operation button on the recorder).
, On the recorder, disable HOLD by sliding the HOLD switch to
the opposite direction of the arrow.
• The lid is not firmly closed.
, Close the lid until it clicks.
• Moisture has condensed inside the recorder.
, Take the MD out and leave the recorder in a warm place for
several hours until the moisture evaporates.
• The dry batteries are weak (“LOW BATT” flashes or nothing
appears).
, Replace the dry batteries with the new one (page 12), or
connect the AC power adaptor to the recorder.
• The dry battery have been inserted incorrectly.
, Insert the battery correctly (page 12).
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• A disc with no track is inserted.
, Replace to another disc.