Sony DVP-NS900V - Manual (Page 79)

Us
ing Va
ri
ous
Addition
a
l Func
tions
79
Controlling the TV
When you set the TV/DVD switch to TV, you
can control the following items with the
supplied remote.
1
Slide the TV/DVD switch to DVD.
2
While holding down [/1, press down on
the scroll key.
“AV P-90” appears in the LCD screen.
3
Release [/1.
4
Toggle the scroll key up or down to
select your AV amplifier (receiver’s)
manufacturer’s code (see the table
below).
5
Press down on the scroll key.
The manufacturer’s code flashes and the
remote is set.
Code numbers of controllable AV
amplifiers (receivers)
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your AV amplifier
(receiver).
If you do not connect an AV amplifier
(receiver), you can control your TV’s volume
by setting the code number to 90 (default).
However, you must first set the code number
of controllable TVs as explained above.
Controlling the AV amplifiers
(receivers)
When you set the TV/DVD switch to DVD,
you can control the volume of the AV
amplifier (receiver) using VOL
+/– .
By pressing You can
[/1 Turn the TV on or off
VOL +/– Adjust the volume of the TV
WIDE MODE Switch to or from the wide
mode of a Sony wide TV
TV/VIDEO Switch the TV’s input source
between the TV and other input
sources
CH +/–, number
buttons, and
ENTER Select the channel of the TV
Controlling the volume of your AV
amplifier (receiver) with the remote
[/1
VOL +/–
TV/DVD
switch
LCD screen
Scroll key
Manufacturer Code number
Sony 80, 88, 89, 91
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96