Sony STR-DA4600ES - Manual (Page 160)

160 GB
The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the desired
satellite radio service (page 65).
The Control for HDMI function does not
work.
• Check the HDMI connection (page 25).
• Make sure “Control for HDMI” is set to
“ON” in HDMI settings menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• If you change the HDMI connection,
connect/disconnect the AC power cord, or
there is a power failure, repeat the
procedures of “Preparing for the
“BRAVIA” Sync” (page 97).
• If you select “HDMI A” or “HDMI A B,”
after you have selected “HDMI B” or
“OFF,” the Control for HDMI function
may not work properly for a while. This is
because the component connected to the
HDMI OUT A jack must re-recognize the
receiver that is equipped with the Control
for HDMI function. If the Control for
HDMI function does not work properly for
a long time, perform the steps given in
“Preparing for the “BRAVIA” Sync”
(page 97).
• When you select “HDMI B” or “OFF,” the
Control for HDMI function does not work
properly.
• When “Control for HDMI” is set to
“OFF,” the “BRAVIA” Sync does not
work properly, even if a component is
connected to the HDMI IN jack.
• The types and the number of components
which can be controlled by the “BRAVIA”
Sync are restricted in the HDMI CEC
standard as follows.
– Recording component (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
components
– Playback component (Blu-ray Disc
Player, DVD player, etc.): up to 3
components
– Tuner-related component: up to 4
components
– AV receiver (audio system): up to 1
component
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the “Audio Out”
settings in HDMI settings menu to
– “TV+AMP” if you want to listen to the
sound from the TV speaker and
receiver.
– “AMP” if you want to listen to the
sound from the receiver.
• When you connect the receiver to a video
component (projector, etc.), sound may
not be output from the receiver. In this
case, select “AMP.”
• You cannot listen to the sound of a
component connected to the receiver while
a TV is selected as the input on the
receiver.
– Change the input of the receiver to
HDMI when you want to watch a
program on a component connected to
the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
Control for HDMI