Sony STR-DA4600ES - Manual (Page 161)

161 GB
A
d
ditio
n
al Inf
o
rm
ati
o
n
• When using the Control for HDMI
function, you cannot control the connected
component using TV’s remote.
– Depending on the connected component
and TV, you may need to set up the
component and TV. Refer to the
operation instructions supplied with
each component and TV.
– Change the input of the receiver to the
HDMI input connected to the
component.
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 106).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Cannot find the server.
• Search the server using the “Server
Search” function (page 80).
• Check the following:
– Is the router turned on?
– If there is another device between this
device and the router, check that device
is turned on.
– Are all of the cables connected correctly
and securely?
– Is the settings to make sure that they
match the router’s settings (DHCP or
fixed IP address)?
• When using a computer, check the
following:
– The built-in firewall settings for the
computer’s operating system.
– The firewall settings of your security
software. To check the firewall settings
of your security software, refer to your
security software’s Help section.
• Register this device with the server. For
details, refer to the instructions supplied
with the server.
• Wait for a few moments, and then try
connecting to the server again.
Cannot find or play back the content on
the server.
• On the “ Music,” “ Photo,” and
“ Video” screens, the receiver
displays only the content that can be
played back with the receiver from among
the content offered by the server within the
DLNA guidelines.
• The content without a [*] mark before the
name is offered by the server as that
defined in the DLNA guidelines, and it can
be played back with the receiver.
The content with a [*] mark before the
name is offered by the server as that not
defined in the DLNA guidelines, and it
may be played back with the receiver.
• There may be content that is not displayed
even if it can be played back with the
receiver because it is not defined in the
DLNA guidelines. However, the receiver
may not be able to play back the content,
even if it is defined in the DLNA
guidelines.
• The availability of certain content may
differ, depending on the server software. If
the content is not displayed or cannot be
played back, try the supplied VAIO Media
plus application software as your server
software.
Remote commander
Network
continued