Asus TW510-E2 - Manual (Page 110)

5 - 3 0 5 - 3 0 5 - 3 0 5 - 3 0 5 - 3 0 C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p
F1:Help ↑↓ ↑↓ ↑↓ ↑↓ ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →← →← →← →← →←: Select Menu Enter: Select Sub-menu F10: Save and Exit
Phoenix-Award BIOS CMOS Setup Utility
Advanced
5.4.5 5.4.5 5.4.5 5.4.5 5.4.5 PCIPnP PCIPnP PCIPnP PCIPnP PCIPnP
This menu shows the PCIPnP configuration settings. Select an item then
press <Enter> to display a pop-up menu with the configuration options.
Select Menu
Item Specific Help
BIOS can automatically
configure all the boot
and Plug and Play
compatible devices. If
you choose Auto, you
cannot select IRQ DMA
and memory base address
fields, since BIOS
automatically assigns
them.
PCIPnP
Resources Controlled By [Auto]
IRQ Resources
PCI/VGA Pallete Snoop [Disabled]
** PCI Express relative items **
Maximum Payload Size [4096]
Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto]
Allows automatic or manual assignments of IRQ resources to boot devices
and Plug and Play devices. Configuration options: [Auto] [Manual]
When the item R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y is set to [Auto], the item
IRQ Resources is grayed out and not user-configurable. Refer to the
section “IRQ Resources” for information on how to enable this item.
PCI/VGA Pallet Snoop [Disabled] PCI/VGA Pallet Snoop [Disabled] PCI/VGA Pallet Snoop [Disabled] PCI/VGA Pallet Snoop [Disabled] PCI/VGA Pallet Snoop [Disabled]
Some non-standard VGA cards, like graphics accelerators or MPEG video
cards, may not show colors properly. Setting this field to [Enabled]
corrects this problem. If you are using a standard VGA card, leave this field
to the default setting [Disabled]. Configuration options: [Disabled]
[Enabled]
Maximum Payload Size [4096] Maximum Payload Size [4096] Maximum Payload Size [4096] Maximum Payload Size [4096] Maximum Payload Size [4096]
Sets the maximum TLP payload size (in bytes) for PCI Express devices.
Configuration options: [128] [256] [512] [1024] [2048] [4096]