Asus TW510-E2 - Manual (Page 33)

2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2
3. When released, pull up the drive
bay lock bar. Underneath the lock
bar are two pegs that match the
holes on the drive bay. This
mechanism secures the drive to
the bay in place of screws.
4. While holding up the drive lock
bar, carefully insert a 5.25-inch
drive into the bay, until the
back of the drive aligns to the
rear edge of the drive cage.
5. Connect the IDE cable to the IDE
connector on the back of the
drive.
6. Connect a 4-pin plug from the
power supply to the power
connector on the back of the
drive.
I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e
P o w e r p l u g P o w e r p l u g P o w e r p l u g P o w e r p l u g P o w e r p l u g
D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s
L o c k p e g s L o c k p e g s L o c k p e g s L o c k p e g s L o c k p e g s
Due to space constraints inside the chassis, do not insert the drive all
the way at this time. This will allow you enough space to easily connect
the drive cables.