Sony HT-CT500 - Manual (Page 100)

100 US
• Remove any obstacles in the path between
the remote and the front panel display.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
The volume turns down when the output
method changes from the TV speaker to the
system speaker.
• The Volume Limit function is working. For
details, see “Using the Volume Limit
function” (page 62).
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use the buttons on the subwoofer for this
operation.
1
Press ?/1 to turn on the power.
2
Press INPUT SELECTOR, VOLUME –,
?/1 at the same time.
“COLD RESET” appears and the system is
reset. The system menu, sound field, etc.,
return to the default settings.
Formats supported by this
system
Digital input formats supported by this system
are as follows.
* Linear PCM accepts sampling frequencies of no
more than 48 kHz.
AUDIO POWER SPECIFICATIONS
for the U.S. model
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 4 ohm loads, both
channels driven, from 180 -
20,000 Hz; rated 60 watts
per channel minimum RMS
power, with no more than
1 % total harmonic
distortion from 250 milli
watts to rated output.
Amplifier Section
U.S. models:
Power output (reference): RMS output power
FL/FR/C*: 100 watts (per
channel at 4 ohms, 1 kHz,
10 % THD)
Subwoofer: 100 watts (4
ohms, 100 Hz, 10 % THD)
Canadian models:
Power output (rated):
FL/FR: 80 W + 80 W (at 4
ohms, 1 kHz, 1 % THD)
Power output (reference): RMS output power
FL/FR/C*: 100 watts (per
channel at 4 ohms, 1 kHz,
10 % THD)
Subwoofer: 100 watts (4
ohms, 100 Hz, 10 % THD)
Specifications
Format Supported/Not supported
Dolby Digital a
DTS a
Linear PCM (2ch)* a
Linear PCM (5.1ch,
7.1ch)* (Only on
HDMI) a
Dolby Digital Plus ×
Dolby True HD ×
DTS-HD Ч