Sony SRS-X9 - Manual (Page 172)

Personal Audio System
SRS-X9
Connecting to a Wi-Fi network using "SongPal" (iPhone)
You can connect the speaker to a Wi-Fi network using "SongPal" installed on your iPhone.
First, make a BLUETOOTH connection between the speaker and the iPhone. Then configure the Wi-Fi settings.
Complete step 10 within 15 minutes after turning on the speaker. If the settings are not completed within 15 minutes, the
speaker will turn off automatically.
Check the following before starting the operation.
Connect your iPhone to the wireless router using IEEE 802.11b or IEEE 802.11g.
Disconnect the LAN cable from the speaker.
Place the speaker closer to the wireless router.
Set the Wi-Fi antenna on the rear to the upright position.
Before starting this procedure, be aware that the setting information of your Wi-Fi network will not be protected until the
setting is complete. After the setting is complete, the setting information of your Wi-Fi network will be protected again
when you set wireless LAN security.
1. Have the Wi-Fi network name (SSID) and password of the wireless router to be used available for reference.
For the SSID and password, refer to the operating instructions of the wireless router.
2. Install the application "SongPal" on your iPhone.
Search for "SongPal" at Google Play™.
3. Turn on the speaker.
The (on/standby) indicator lights up in green, then the LINK indicator begins to flash.
When you configure the settings of the speaker for the first time after purchase, or after you initialize the speaker,
wait until the LINK indicator turns off (about a minute).
4. Tap the (BLUETOOTH) PAIRING button once.
The (BLUETOOTH) indicator begins to flash in white.
Help Guide
How to Use
159