Sony STR-DN1030 - Manual (Page 108)

108 US
D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF
06\4420297142_US\US06REM_STR-DN1030-CEL.fm masterpage: Left
STR-DN1030
4-420-297-14(2)
3
Press the numeric buttons to
enter the numeric code.
If more than one code exists, try to enter
either one which corresponds to the
equipment including TV.
Use the tables on page 108–111 to find
the numeric code(s) corresponding to the
equipment.
Note
Only the codes in the 500’s are valid for the TV
button.
4
Press ENT/MEM.
Once the numeric code has been verified,
the RM SET UP button slowly flashes
twice and the remote control
automatically exits the programming
mode.
5
Repeat steps 1 to 4 to program
other equipment.
Note
The RM SET UP button turns off while a numeric
button is pressed.
To cancel programming
Press RM SET UP during any step. The
remote control automatically exits the
programming mode.
To activate the input after
programming
Press the programmed button to activate the
input you want.
If programming is
unsuccessful, check the
following:
• If the RM SET UP button does not light up
in step 1, the batteries are weak. Replace
both batteries.
• If the RM SET UP button flashes 5 times in
quick succession while entering the numeric
code, an error has occurred.
Start again from step 1.
Use the numeric codes in the tables below to
program non-Sony equipment and also Sony
equipment that the remote control is normally
unable to control. Since the signal from the
remote control received by the equipment
differs by its model and the year, more than
one numeric code may be assigned to the
equipment. If you fail to program your remote
control using one of the codes, try using other
codes.
Notes
• The numeric codes are based on the latest
information available for each brand. There is a
chance, however, that your equipment will not
respond to some or all of the codes.
• All of the input buttons on this remote control may
not be available when used with your particular
equipment.
To control a CD player
To control a DAT deck
The numeric codes
corresponding to the equipment
and the maker of the equipment
Maker Code(s)
SONY 101, 102, 103
DENON 104, 123
JVC 105, 106, 107
KENWOOD 108, 109, 110
MAGNAVOX 111, 116
MARANTZ 116
ONKYO 112, 113, 114
PANASONIC 115
PHILIPS 116
PIONEER 117
TECHNICS 115, 118, 119
YAMAHA 120, 121, 122
Maker Code(s)
SONY 203
PIONEER 219