Sony STR-DN1030 - Manual (Page 116)

116 US
D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF
06\4420297142_US\US07ADD_STR-DN1030-CEL.fm masterpage: Left
STR-DN1030
4-420-297-14(2)
• Check that the connecting cords are away
from a transformer or motor, and at least
3 meters (10 feet) away from a TV set or
fluorescent light.
• Move your audio equipment away from
the TV.
• The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There is no sound, or only a very low-
level sound is heard from specific
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
equipment may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the equipment.
If both channels are output from the
headphones, the front speaker may not be
connected to the receiver correctly. Check
the connection of the front speaker which
is not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog equipment,
analog equipment requires both L and R
jack connections. Use an audio cord (not
supplied).
• Adjust the speaker level (page 94).
• Check that the speaker settings are
appropriate for the setup using the Auto
Calibration menu or “SP Pattern” in the
Speaker Settings menu. Then check that
sound is output from each speaker
correctly, using “Test Tone” in the
Speaker Settings menu.
• Some discs have no Dolby Digital
Surround EX information.
• Check that the subwoofer is connected
correctly and securely.
• Make sure you have turned on your
subwoofer.
• Depending on the selected sound field, no
sound will be available from the
subwoofer.
• When all speakers are set to “Large” and
“NEO6 CIN” or “NEO6 MUS” is selected,
there is no sound from the subwoofer.
There is no sound from a specific
equipment.
• Check that the equipment is connected
correctly to the audio input jacks for that
equipment.
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
equipment.
• Check the INPUT MODE (page 88).
• Check that the equipment is connected
correctly to the HDMI jack for that
equipment.
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback equipment,
you may need to set up the HDMI setting
of the equipment. Refer to the operating
instructions supplied with each
equipment.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound,
especially for the 1080p, Deep Color
(Deep Colour) or 3D transmission.
• Sound may not be output from the receiver
while the GUI appears on the TV screen.
Press GUI MODE to select “GUI OFF”.
• Audio signals (format, sampling
frequency, bit length, etc.) transmitted
from an HDMI jack may be suppressed by
the connected equipment. Check the setup
of the connected equipment if the image is
poor or the sound does not come out of the
equipment connected via the HDMI cable.
• When the connected equipment is not
compatible with copyright protection
technology (HDCP), the image and/or the
sound from the HDMI TV OUT jack may
be distorted or may not be output. If this is
the case, check the specification of the
connected equipment.