Sony STR-DN1030 - Manual (Page 113)

113 US
D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF
06\4420297142_US\US07ADD_STR-DN1030-CEL.fm masterpage: Right
STR-DN1030
4-420-297-14(2)
Ad
ditional Inf
o
rmation
On placement
• Place the receiver in a location with adequate
ventilation to prevent heat buildup and
prolong the life of the receiver.
• Do not place the receiver near heat sources,
or in a place subject to direct sunlight,
excessive dust, or mechanical shock.
• Do not place anything on top of the cabinet
that might block the ventilation holes and
cause malfunctions.
• Do not place the receiver near equipment
such as a TV, VCR, or tape deck. (If the
receiver is being used in combination with a
TV, VCR, or tape deck, and is placed too
close to that equipment, noise may result,
and picture quality may suffer. This is
especially likely when using an indoor
antenna (aerial). Therefore, we recommend
using an outdoor antenna (aerial).)
• Use caution when placing the receiver on
surfaces that have been specially treated
(with wax, oil, polish, etc.) as staining or
discoloration of the surface may result.
On operation
Before connecting other equipment, be sure to
turn off and unplug the receiver.
On cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.
On Bluetooth communication
• Bluetooth devices should be used within
approximately 10 meters (33 feet)
(unobstructed distance) of each other. The
effective communication range may become
shorter under the following conditions.
– When a person, metal object, wall or other
obstruction is between the devices with a
Bluetooth connection
– Locations where a wireless LAN is
installed
– Around microwave ovens that are in use
– Locations where other electromagnetic
waves occur
• Bluetooth devices and wireless LAN
(IEEE 802.11b/g) use the same frequency
band (2.4 GHz). When using your Bluetooth
device near a device with wireless LAN
capability, electromagnetic interference may
occur. This could result in lower data
transfer rates, noise, or inability to connect.
If this happens, try the following remedies:
– Use this receiver at least 10 meters
(33 feet) away from the wireless LAN
device.
– Turn off the power to the wireless LAN
equipment when using your Bluetooth
device within 10 meters (33 feet).
– Install this receiver and Bluetooth device
as closer to each other as possible.
• The radio waves broadcast by this receiver
may interfere with the operation of some
medical devices. Since this interference may
result in malfunction, always turn off the
power on this receiver and Bluetooth device
in the following locations:
– In hospitals, on trains, in airplanes, at gas
stations, and any place where flammable
gasses may be present
– Near automatic doors or fire alarms
continued