Sony STR-DH700 - Manual (Page 9)

9 US
About the indicators on the display
SW LFE
SP A
SP B
L C
SL S
PL IIx OPT HDMI CAT DTS -ES 96/24 MEMORY
MONO SLEEP ST D.RANGE S-AIR COAX NEO:6 SAT
SB SBL
R
SR
SBR
DEX
1 2 3 4 5 7
qd q; 9 qa qs 8
6
Name Function
A SW
Lights up when subwoofer
selection is set to “YES” (page
51) and the audio signal is
output from the SUBWOOFER
jack.
B LFE Lights up when the disc being
played back contains an LFE
(Low Frequency Effect)
channel and the LFE channel
signal is actually being
reproduced.
C SP A/SP B Lights up according to the
speaker system used. However,
these indicators do not light up
if the speaker output is turned
off or if headphones are
connected.
Name Function
D Input
indicators
OPT
COAX
HDMI
Light up to indicate the current
input.
Lights up when INPUT MODE
is set to “AUTO” and the
source signal is a digital signal
being input through the
OPTICAL jack or when
INPUT MODE is set to “OPT”.
However, “NO INPUT”
appears on the display when
INPUT MODE is set to “OPT”
and no digital signal is input
through the OPTICAL jack
(page 88).
Lights up when INPUT MODE
is set to “AUTO” and the
source signal is a digital signal
being input through the
COAXIAL jack or when
INPUT MODE is set to
“COAX”. However, “NO
INPUT” appears on the display
when INPUT MODE is set to
“COAX” and no digital signal
is input through the COAXIAL
jack (page 88).
Lights up when the receiver
recognizes a component
connected via an HDMI IN
jacks (page 23).
continued