Sony MHC-ZX10 - Manual (Page 29)

29
The CD Player
15
Move the multi stick toward b or B
repeatedly to select “Direction Set
Up ?”, then press PUSH ENTER.
16
Move the multi stick toward b or B
repeatedly to select “1 Way” to record
on one side, or “Cycle” (or “Relay”) to
record on both sides, then press PUSH
ENTER.
17
Press REC PAUSE/START.
Recording starts.
To stop recording
Press x.
To cancel the menu operation
Press MODE SELECT.
To check the order
1 Press FUNCTION repeatedly until “CD”
appears in the display.
2 Press MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select “CD Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select “PGM Check Clear ?”, then press
PUSH ENTER.
5 Move the multi stick toward b or B.
The disc number and the track number appears.
6 After checking the program, press MODE
SELECT.
To cancel Program Edit
1 Press FUNCTION repeatedly until “CD”
appears in the display.
2 Pres MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select “CD Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select “Play Mode Set Up ?”, then press
PUSH ENTER.
5 Move multi stick toward b or B repeatedly to
select “All Discs” or “1 Disc”, then press PUSH
ENTER.
The tracks continue playing in their original order.
The Tape Deck
Tip
When you want to reduce the hiss noise in low-level
high-frequency signals, do the following procedure
after pressing CD SYNC in step 12 in the previous
page.
1 Press MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
2 Move the multi stick toward b or B repeatedly to
select “TAPE Set Up ?”, then press PUSH
ENTER.
3 Move the multi stick toward b or B repeatedly to
select “DOLBY NR Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly to
select “On”, then press PUSH ENTER.
“DOLBY NR” appears in the display.
To return to the original setting, repeat steps 1
thruogh 4 again, to select “Off” in the step 4.
continued