Sony MHC-ZX10 - Manual (Page 9)

9
Getting Started
To tune in a station with a weak
signal
Press m or M repeatedly in step 2 to tune in
the station manually.
To set another station to an
existing preset number
Start over from step 1. After step 5, press . or
> to select the preset number where you want
to store the other station, then press PUSH
ENTER.
You can preset a new station in the selected preset
number.
To erase a preset station
1 Press TUNER/BAND to select FM or AM.
2 Press MODE SELECT repeatedly to select
“Set Up Mode”, then press PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select “TUNER Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select “TUNER Erase ?”, then press PUSH
ENTER.
5 Move the multi stick toward b or B repeatedly
to select the preset number you want to erase,
then press PUSH ENTER.
Select “TUNER Ers FM ALL” (or “TUNER
Ers AM ALL”) when you want to erase all the
preset stations.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or a power failure occurs.
To change the AM tuning
interval
(Except for the European model)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down MODE SELECT,
turn the power back on. When you switch the
interval, AM preset stations are erased. To switch
back to the original interval, repeat the same
procedure.