Alliance Laundry Systems 512685R2 - Manual (Page 28)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 26 512685
Vending
Coin Slide Guards
(Metered Models)
Using sheet metal screws from accessories bag
(located in lower cylinder), install coin slide guards
(located in accessories bag in lower cylinder) to front
of dryer’s control cabinet. Refer to Figure 33.
Figure 33
NOTE: Coin slides and coin drawers are shown for
illustration only. You must obtain them locally.
Coin Slide Control
(Coin Slide Models Only)
Power-Up Mode
When power is applied to the dryer, the control will
enter the Ready Mode. If the control was powered
down during a running a cycle, the IN USE LED will
flash once and the control will enter Start Mode. If the
dry time dipswitch settings have not been changed
from factory default, the IN USE LED will flash once.
Ready Mode
In Ready Mode, the control waits for the vend to be
satisfied before entering Start Mode.
Start Mode
In Start Mode, the vend has been satisfied, but the
Start button has not been pressed. The IN USE LED
will be lit. The timer will not count down until the
Start button is pressed.
Run Mode
In Run Mode, the control is running a cycle. The
IN USE LED is lit.
Door Open Mode
In Door Open Mode, the control turns off the heater
and motor when the door is opened during a run cycle.
The timer will continue to count down time and the
IN USE LED is lit.
End of Cycle Mode
In End of Cycle Mode, a cycle is complete and the
IN USE LED is off. The control remains in this mode
until the door is opened or additional vend has been
satisfied.
D784I
1 Coin Slide Guard 2 Sheet Metal Screws
PUSH TO START
IN USE
IN USE
PUSH TO START
FABRIC SELECTOR
FABRIC SELECTOR
PERM PRESS
NORMAL
DELICATE
FLUFF
(NO HEAT)
PERM PRESS
NORMAL
DELICATE
FLUFF
(NO HEAT)
D784I
2
2
1 1