Alliance Laundry Systems 512685R2 - Manual (Page 33)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Vending
31 512685
Slide Extension
(Coin Slide Models)
1. Remove slide extension parts from parts
accessories bag included in unit.
2. If installing a Greenwald coin slide, position
extension lever (to be installed on extension
bracket) with arm that has one star facing down.
Refer to Figure 35.
3. If installing a Monarch or ESD coin slide,
position lever with arm that has two stars facing
down. Refer to Figure 35.
4. Install extension lever with rounded corner facing
away from extension bracket using bolt, one or
two flat washers (shims) (use number of washers
included in kit) and nut. Refer to Figure 36.
Make sure washers are flat against bracket.
5. Torque nut between 2 and 2.26 Nm (18 and 20
inch-pounds), or tighten nut firmly.
6. Install extension spring in bracket hole and hole
in upper arm of lever. Refer to Figure 36.
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
Installing Extension Onto Coin Slide:
Option 1
1. Install slide extension onto top of coin slide using
two remaining screws and lockwashers. Refer to
Figure 37.
2. Insert coins and partially extend coin slide.
3. Insert coin slide on its side through meter case
opening. Then rotate 90 degrees to its proper
orientation.
4. Return coin slide and hook slide pins onto meter
case.
5. Continue coin slide installation according to
manufacturer’s instructions.
TLW2088N
Figure 35
TL2089N
Figure 36
GREENWALD
COIN SLIDE
MONARCH OR ESD
COIN SLIDE
ONE STAR
TWO STARS
TLW2089N
EXTENSION BRACKET
SPRING BOLT
ONE OR TWO
FLAT WASHERS (SHIMS)
NUT
EXTENSION LEVER
STAR(S) FACING DOWN
LOOPS
ROUNDED CORNER
TLW1564K
Figure 37
COIN SLIDE
SLIDE
EXTENSION
ATTACHING
SCREWS
LOCKWASHERS