Asus RS100-E5-PI2 - Manual (Page 51)

ASUS RS100-E5-PI2 4-5
2. RAID controller selection (3-pin RAID_SEL1)
This jumper allows you to select the RAID configuration utility to use when you
create disk arrays. Place the jumper caps over pins 1-2 if you want to use the LSI
Logic Embedded SATA RAID Setup Utility (default); otherwise, place the
jumper caps to pins 2-3 to use the Intel ® Matrix Storage Manager.
3. Force BIOS recovery setting (3-pin RECOVERY1)
This jumper allows you to quickly update or recover the BIOS when it gets
corrupted.
To update the BIOS:
1. Prepare a floppy disk that contains the latest BIOS for the motherboard
(xxxx-xxx.ROM) and the AFUDOS.EXE utility.
2. Set the jumper to pins 2-3.
3. Insert the floppy disk then turn on the system to update the BIOS.
4. Shut down the system.
5. Set the jumper back to pins 1-2.
6. Turn on the system.
P5BV-M/RS100-E5 RAID_SEL1 Setting
®
P5BV-M/RS100-E5
2 3 1 2
RAID_SEL1
LSI RAID ROM
(Default)
INTEL RAID ROM
P5BV-M/RS100-E5 BIOS Recovery Setting
®
P5BV-M/RS100-E5
2 3 1 2
RECOVERY1
(Default)
Normal BIOS recovery