Asus RS100-E5-PI2 - Manual (Page 112)

6-18 Chapter 6: RAID Configuration
6.3.2 Initializing the virtual drives
After creating the RAID set, you must initialize the virtual drives. You may initialize
the virtual drives of a RAID set using the Initialize or Objects command on the
Management Menu.
Using the Initialize command
To initialize the virtual drive using the Initialize command:
1. From the Management Menu, highlight Initialize, then press <Enter>.
2. The screen displays the available RAID set and prompts you to select the
virtual drive to initialize. Use the arrow keys to select the virtual drive from the
Virtual Drive selection, then press the <SpaceBar>.
LSI Software RAID Configuration Utility Ver A.53 Sep 06, 2007
Use Cursor Keys to Navigate Between Items And Press Enter To Select An Option
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
Initialize Virtual Drive(s)
LSI Software RAID Configuration Utility Ver A.53 Sep 06, 2007
SPACE-(De)Select, F10-Check Consistency
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
Select VD
Virtual Drive(s) Configured
LD RAID Size #Stripes StripSz Status
0 10 154494MB 4 64 KB ONLINE
Virtual Drives
Loical Drive 0