Asus RS100-E5-PI2 - Manual (Page 87)

ASUS RS100-E5-PI2 5-25
5.5.1 APM Configuration
Restore on AC Power Loss [Last State]
When set to Power Off, the system goes into off state after an AC power loss.
When set to Power On, the system goes on after an AC power loss. When set to
Last State, the system goes into either off or on state, whatever the system state
was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled]
When set to [Enabled], the system enables the RI to generate a wake event while
the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On PME# [Disabled]
Allows you to enable or disable the Resume On PME# function.
Configuration options: [Disabled] [Enabled]
Resume On RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake event. When this item is
set to [Enabled], the items RTC Alarm Date, RTC Alarm Hour, RTC Alarm Minute,
and RTC Alarm Second appear with set values.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Resume On RTC Alarm item is set
to Enabled.
RTC Alarm Date [15]
To set the alarm date, highlight this item and press the <+> or <-> key to
make the selection.
Configuration options: [Everyday] [1] [2] [3]...[31]
RTC Alarm Hour [12]
To set the alarm hour, highlight this item and press the <+> or <-> key to
make the selection.
Configuration options: [00] [01] [02] [03]...[23]
RTC Alarm Minute (Second) [30]
To set the alarm minute (second≠), highlight this item and press the <+> or
<-> key to make the selection.
Configuration options: [00] [01] [02] [03]...[59]
BIOS SETUP UTILITY
Power
<Enter> to select
whether or not to
restart the system
after AC power loss.
APM Configuration
Restore on AC Power Loss [Last State]
Resume On Ring [Disabled]
Resume On PME# [Disabled]
Resume On RTC Alarm [Disabled]