Asante Technologies 1012 - Manual (Page 43)

Page 2-9
Using the 3in1 Port
Figure 2-4 Interconnecting Hubs on Thin Ethernet Backbone
❖ Note: The terminator may be used either at one end of a
T-connector, or at the end of a cable.
❖
RJ21 10 BASE-T PORTS IN or OUT AUI PARTITION
TRAFFIC
RS232
THROUGH
AMS LINK
UP=PC
DOWN=TERMINAL
END
3-IN-1 UPLINK
BNC Spare Fuse in Fuse Holder
2A/250V Slow Blow Fuse Replace Only With Fuse of Same Rating
RJ21 10 BASE-T PORTS IN or OUT AUI PARTITION
TRAFFIC
RS232
THROUGH
AMS LINK
UP=PC
DOWN=TERMINAL
END
3-IN-1 UPLINK
BNC Spare Fuse in Fuse Holder
2A/250V Slow Blow Fuse Replace Only With Fuse of Same Rating
Thin Ethernet Backbone
for Segment B connected to
bridge external port with a MAU
RJ21 10 BASE-T PORTS IN or OUT AUI PARTITION
TRAFFIC
RS232
THROUGH
AMS LINK
UP=PC DOWN=TERMINAL
END
3-IN-1 UPLINK
BNC
Spare Fuse in Fuse Holder
2A/250V Slow Blow Fuse Replace Only With Fuse of Same Rating
Terminator
Terminator
Thin Ethernet Backbone for Segment A connected to
3in1 Port BNC connector (bridge hub port)
AsantéBridge 1012
AsantéHub 1012
AsantéHub 1012