Taking pictures using burst mode, P153) – Panasonic DMC-GH3KBODY User Manual
Page 153
153
Recording
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
Pictures taken with a burst speed of [SH] will be recorded as a single burst group
1
Set the drive mode dial to [
].
2
Focus on the subject and take a picture.
A When Burst Mode is set to high speed [H].
•
Hold down the shutter button fully to activate the Burst Mode.
∫
Changing the burst speed
1
Select [Burst Rate] in the [Rec] menu.
2
Press 3/4 to select the burst speed and then press [MENU/SET].
[SH]
(Super high
speed)
[H]
(High speed)
[M]
(Middle
speed)
[L]
(Low speed)
Burst speed
(pictures/second)
20
6
4
2
Live View during Burst
Mode
None
None
Available
Available
¢1
With RAW files
—
18
¢2, 3
Without RAW files
Max. 80
Depends on the capacity of the card
¢3
¢1 Number of recordable pictures
¢2 Depending on the recording conditions, the number of frames in a burst may be
reduced. (For example, when [i.Resolution] of the recording menu is set to
[EXTENDED], the number of frames in a burst may be reduced)
¢3 Pictures can be taken until the capacity of the card becomes full. However the burst
speed will become slower halfway. The exact timing of this depends on the aspect
ratio, the picture size, the setting for the quality and the type of card used.
•
The Burst Mode speed may become slower depending on the following settings.
–
[Picture Size]
/[Sensitivity]
/[Focus Mode]
/[Focus/
Release Priority]
•
for information about RAW files.
AFS
AFS
H
A